The accuracy of the radial drilling machine is stable and the quality of the original factory delivery is guaranteed

1, gearbox automatic oil supply system: the design principle of the rocker drill is vertical gear, the traditional lubrication method is to use the gear speed to throw the lubricating oil belt to the above gear lubrication, practice has proved that this way there is no way to throw the oil to the above, the traditional way of the above gear is dry grinding. After a few months of use, the customer found that the noise was loud, and the gear above should be replaced after one to two years.
2, Taiwan Fu rocker drill to take lubrication from the bearing into, full lubrication of the bearing, from the bearing down to the gear, as long as the frequent oil change, not brutal operation, bearing, gear no bad reason.
3, the company developed the motor, using the principle of Taiwan turret milling motor, the rotor height is reduced, the thickness is increased, the torque of the motor is increased, and the power of the motor is reduced. The experiment proves that the motor used by the company now saves 2 kWh per hour compared with the traditional motor.
4, energy-saving motor calculated according to 12 hours a day, 12*2=24 degrees a day 24 degrees *365 days =8760 degrees, two years to save a piece of equipment.
5, copper core motor positive and negative rotation high low speed low speed 34 turn can be directly tapping.
6, column safety locking, the traditional column is generally locked without a safety device, this setting should be more than 2 AC contactors. Taifu drilling machine products with automatic safety protection device in the case of workers forget to loosen the lock, it can automatically power off to prevent the rocker arm lifting pull column, the lifting screw mother slip wire.
7, the spindle has a stroke switch protection system, in the automatic feed, forget to release the automatic feed will make the spindle top car, this protection spindle is not easy to be damaged.
8, automatic oil pump system: change the traditional dry grinding, copper turbine full lubrication, wear resistance.
9, ultrasonic quenching gear: wear resistance, high hardness, quenching is to be done in accordance with the operating procedures, not with fire can be, quenching, grinding process do not just say, noise is about the quality of the detection gear. The grinding noise is small, no noise. The noise level is above 100 decibels. All gears are ground with CNC worm grinding precision.
10. The switches used on the machine tool are brand switches, and the AC contactor is directly supplied by Shanghai Electric Appliance Factory.
11, screw brand manufacturers, brand manufacturers are not directly out of the round steel car, but in strict accordance with the process requirements, tempering heat treatment and other strict process requirements, special screw equipment, the use of cylindrical grinding after high finish, service life more than 2 times the ordinary screw. The mother wire adopts copper wire mother. The price is three times that of traditional screws.
12, Taiwan Fu rocker drill in strict accordance with the production process requirements. First pull the parallelism of the spindle box with a dial indicator, measure the swing of the rocker arm, and then measure the circle of the spindle box. and so on